Mount CO2 regulator as close as possible to air cylinder for proper function, any length away adds delay and possible incomplete release. C02 Handle Release is meant to operate at conditions of 80 psi and higher, the higher the PSI the faster and better the function of this system. Cable needs to have loose swooping bends, failure to test beforehand/and or constrictive bends can cause this handle to operate slower or incorrectly. 99 Motion Raceworks Billet Valve Cover Breathers Clear Anodized (Pair) 32-120. Note: Please test operation prior to going to the racetrack. Motion Raceworks CO2 Shifter Kit w/ Bottle 16-150. Improper Installation, hookup, or misuse may result in improper function of this part. The biggest thing is you need to TEST this before heading to the track. Please note that even though this kit is meant to be a complete kit, and has been strenuously tested, refined, and appropriately changed to work under demand of today’s chassis, care needs to be taken when installing. Fire Pull Cable Bracket MOTION RACEWORKS OPERATOR Shifter (Single and. Our design of this kit was made to operate under 80 psi, though, it operates better the higher you go up to 120psi. corrosion-resistant walls, perfect for carbon dioxide Brushed exterior finish. There are enough fittings in this kit to plumb the following. This all inclusive kit comes with top quality fittings, regulator, line, and bottle to plumb any Boost Controller system on the market. When installed properly this release kit will make for simple, reliable, release of your parachute while keeping both hands firmly planted on the wheel. The Motion Raceworks Single Turbo C02 Kit takes the guess work out of fittings. ![]() Available in both single and dual cable styles. We spent a ton of time designing, redesigning, and perfecting this kit. CO2 Solenoid Weld or Clamp on mounting bracket.Cable with necessary connection hardware.Our kit is designed to WELD OR CLAMP on and provides a complete solution with no guess work or any additional fabrication. When it is most important to pay attention to the track and things are moving fast, launch your parachute with the push of a button rather than taking your hand off and trying to find a handle mounted above/out of the way of eyesight. The Motion CO2 Release handle kit is the answer to keeping your hands on the wheel at the big end of the track. ***Note: these bottles are only date certed.Motion Raceworks Billet CO2 Activated Parachute Handle Release Lever & Cable Mount Kit (1) 80PSI Regulator with Bottle Pressure Gauge.(1) Sensor T (Male,Female, Female) 1/8" NPT for Dome Pressure Sensor on Wastegate.(3) Straight Nickel Plated Push to Connect 1/8" NPT.(6) 90 degree Nickel Plated Push To Connect 1/8" NPT.This is a very standard fitting size across brands such as Tial, JGS, Precision, Turbosmart, Procharger,and many others. Motionraceworks twinturbo boosted Streetcar Racecar. Our nickel plated fittings are 1/8 NPT which work with nearly every brand wastegate, blow off valve, and solenoid on the market. Motion Raceworks Co2 twin turbo boost control kit with billet bottle bracket riding along in orrgreg Project 200MPH Buick Skylark. This kit is easy to install and comes with everything needed. ![]() The C02 regulator comes preset at 80 psi which is appropriate for nearly every setup (the boost controller regulates pressure down from there). This is a complete add on kit to convert a Non CO2 Assist Operator Series shifter to a CO2 Assist. ![]() The Motion Raceworks Single Turbo C02 Kit takes the guess work out of fittings.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |